Trailer Information

Dump Configuration:	Frameless, standard Quarter frame (available mid 2012) Aluminum frame-type (available mid 2012)
Length:	39′ standard, (427″ bridge length), 8,892 lbs. with 22.5 LP tires 38′ 37′ 36′ 35′ 34′ 32′ 30′ 28′ 26′ 24′
Side Height:	57″ standard. 39′ = 41.4 cubic yards 51″ (6″ lower) 39′ = 36 cubic yards 60″ (3″ higher) 39′ = 44.1 cubic yards 63″ (6″ higher) 39′ = 46.7 cubic yards Frameless End Dump Capacity Chart Close
Side Gauge:	.190 (3/16″) Polished, standard no options available
Floor Thickness:	.250 (1/4″) standard .250 Aluminum belly pad, approx. 84″ long .250 belly pad 24″ long .250 belly pad 12″ long
Nose:	.250 (1/4″) with built in visor, standard no options available
Tailgate:	.190 (3/16″) sheet, 12 degree slope, overslung, standard hinges, rubber sealed, air operated Add grain door, with 2 safety latches Add 2 safety latches only spreader kit, incl. chains, eyes and extra bracing Grain door, latches and spreader kit
Apron:	16″, over suspension setback, standard 6″ apron, 11″ longer body to equate same bridge No apron, 11″ longer body to equate same bridge
Draft Arms:	Aluminum tube, with non-load bearing drop legs, standard Aluminum tube, with load bearing drop legs Aluminum tube, with 2-speed, load bearing drop legs
Tire Carrier:	None, standard Add tire carrier, basket-type, open to curb side
Fenders:	Rear aluminum over tandem, with short (12″) flaps on front edge, standard Add front fenders, smooth aluminum
Steps/Ladders:	Ladder at rear drivers side, over front axle, standard Add folding section to hang ladder down over tire Swing out ladder on nose of trailer Additional ladder in another location, specify in notes below Notes
Primary Suspension:	INTRAAX air-ride tandem, 25,000 lb. capacity each, 50,000 lb. total, wide track axles, big spindles, standard Add UBL lift on front axle, electric wire to front Spread axle configuration, 10′ 2″ including extended fenders and subframe (check state & federal bridge laws)
Auxiliary Suspension(s):	None, standard Watson WC9100, air ride, with lift, 13,000 capacity, single tire and aluminum wheels (incl. extended subframe and fenders, and polished wheels) Travis T-lite air ride liftable 5,200 lb. capacity, with single 16″ aluminum wheels (each) Extend subframe for future customer auxiliary suspension addition (provide make and model) Explain any requests in notes below Other Type
Hub & Drum:	Duralite hubs, Meritor X30 lightweight drums, standard Deduct for cast hub and drum, in lieu of lightweight package
Anti-lock Brakes:	Wabco 4 sensor / 2 module (4S/2M), standard no options available
Wheels:	Aluminum, 4 polished and 4 machined, standard select size 24.5 x 8.25 wheels select size 22.5 x 8.25 wheels note: wide base options covered below Alcoa Durabrite wheels outside, mill inside 24.5 x 8.25 Alcoa Durabrite wheels outside, mill inside 22.5 x 8.25 none of the above, wide base option selected below Tire & Wheel Weight Chart Close
Tires:	General ST250 or similar trailer tread, 14 ply, standard select size 11R24.5 select size 11R22.5 select size 24.5 low profile select size 22.5 low profile explain any special tire brand model and size in notes below none of the above, wide base option selected below Other Type
Wide Base:	General ST250 or similar trailer tread, 14 ply, standard 445/50 R22.5, Michelin XOne XTE (4), with (4) 22.5 x 14″ polished Alcoa wheels 445/50 R22.5, Continental HTL1 (4), with (4) 22.5 x 14″ polished Alcoa wheels 455/55 R22.5, Michelin XOne XTE (4), with (4) 22.5 x 14″ polished Alcoa wheels 455/55 R22.5, Michelin XOne XZY3 (4), with (4) 22.5 x 14″ polished Alcoa wheels explain any special tire brand model and size in notes below Other Type
Lights/Sidemarker:	TruckLite LED, 3 clearance lights per side, 2 in rear panel & turn signal, standard 5 total pairs of LED lights per side, in lieu of standard 3 7 total pairs of LED lights per side, in lieu of standard 3 explain special requests in notes below Extra pairs of clearance lights in quarter rail, per pair add back up lights, 1 pair at rear Notes
Liner:	None, standard HMW, 3/8″ x 7′, including cover strips HMW, 3/8″ x 12′, including cover strips UHMW RAMEX, 3/8″ x 7′, including cover strips UHMW RAMEX, 3/8″ x 12′, including cover strips UHMW Quicksilver, 3/8″ x 7′, including cover strips UHMW Quicksilver, 3/8″ x 12′, including cover strips explain special request in notes below, such as 1/2″ material or combo thicknesses Liner Weight Chart Close Other Type
Tarp:	None, standard TravisLok, side roll tarp, aluminum bows, aluminum nosecap, flap over gate TravisLok, side roll tarp, aluminum bows, nosecap, fixed small rear cap and flap over gate TravisLok, side roll tarp with flex (plastic) bows and aluminum nosecap TravisLok, side roll tarp with flex (plastic) bows, aluminum nosecap, fixed rear cap and flap over gate Tarp make-ready kit for customer install, includes front nosecap, wind dam/rod stock, bow pockets and hooks on gate explain special requests in notes below add RollRite electric side roll kit add Aero electric side roll over kit add Shurco electric side roll over kit Other Type
Air Plumbing/ Electric options:	1 Push pull valve on side opens tailgate and dumps air, standard (auto separated with grain door option) separate bags and gate, if trailer NOT equipped with grain door add electric line to front for lift Plumb air line to front for customer gauge leave valve(s) on side for bags and gate and put electric lines at coupler on separate 4 way automatic valve to open gate and dump air bags, attached to draft arms of the above two selections (air)
Other Options:	Meritor PSI, tire inflation system (recommended with wide base), per tandem suspension Glycerin filled air gauge to monitor bag pressure, on side, in box at rear Solid flaps across rear of trailer Notes/Special Requests (Describe Below)

Customer Information

Required fields denoted with a "*"
*Name:
*Company:
*Address:
*City:
*State:
*Zip:
*Phone:
Fax:
*E-mail:

 

For any questions, please contact the webmaster at: info@travistrailers.com